LED Panel Light R18

LED Panel Lights work beautifully in any setting. They come in 3 color temperatures to better enhance the atmosphere of any workspace. Because LED Panel Lighting is offered in various sizes, they are suitable for both commercial and residential purposes.

Applications:

Office/Work Space
Walkway Lighting
Decorative Lighting

Description:

Instruction Manual:

• Before installing the lighting fixtures, please read this instruction manual carefully.
• The lighting fixtures should be installed, connected and tested by a certified installer based on regulations.
• Lamps should always be installed or replaced with care.
• Do not use over rated lamp.
• Relamping only can be done when the power is off and the lamp is completely cooled down.
• When a lamp is to be cleaned, switch off the fixture and let it cool down completely. Clean the fixture with a soft cloth and a standard PH neutral detergent. Stainless steel finishing should be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• Warning notice: the luminaries shall, under no circumstance, be covered by insulating matting material.

Installation

Step 1:

1. Cut a hole in the ceiling that is the right size for the panel.

Step 2:

1. Switch off the AC power.
2. Fix the LED driver onto the back of the panel using the screws provided.
3. Insert the AC power conduit into the driver box through the hole on the side of the driver box, and fix the AC power conduit tightly through the hole using suitable wire clamp matching the size of the conduit.
4. Connect the DC wires of the LED panel from the back cover to the LED driver DC output end using the connectors provided. Then, connect the AC power cord to the driver AC input end and the ground wire on the back of the panel using the connectors provided. Make sure all connections are firm and correct.

Step 3:

1. After connecting the DC and AC wires, cover the driver with the driver box and fix the driver box onto the screw holes at the back of the panel using the screws provided.

Step 4:

1. Install the fixture onto the ceiling and secure the fixture using the springs provided.
2. Adjust the position of the fixture properly and clean the surface of the panel if required.
3. After proper installation of the fixture, switch on the AC power to turn on the panel light.